Operating Instructions

Arming

The NOSTART relay system has no user activated arming facility. The NOSTART automatically arms when power is lost from the coil connections for longer than 30 seconds or instantly if +12VDC is lost from both the coil and contact connections. We recommend leaving the DiCK in the cigarette lighter socket until you complete your journey.


Disarming

Insert the DiCK into the vehicle’s 12VDC cigarette lighter socket. The data signal will begin transmitting, when the ignition switch is turned to the "START" position, the NOSTART will allow power to flow to the circuit that has been immobilized.


Programming

To program the NOSTART relays to accept new standard remote control, power is applied across the coil pins. Momentarily press the small button on a master remote, then press the main button on the new remote control. The relay will make a small (very small) click and close the normally open contacts when the new code is accepted.

Once any standard remote is programmed into the NOSTART relay, the master code is automatically disabled.

Master code remote controls are only available to installers and re-sellers.

The coil pins are described below in red.

The polarity of the voltage applied across the pins is bi-directional, the relay is able to correct reverse polarity internally.